/

/

TITAN "Spectra" cord sealing..

Climbing Talk

TITAN "Spectra" cord sealing..

Started by Mark

·

·

6 replies

Archived thread

Replies are closed. Some details, such as access rules and gate codes, may be out of date.

Mark - 14 Aug 2009

Hi I have some Blue Water 5.0mm TITAN "Spectra" cord which I want to seal the ends of.

I have read that you are supposed to cut the core shorter and seal the sheath. Are there any better alternatives?


Numbat - 14 Aug 2009

Use a hot knife. Go to the kitchen, get a knife - any will do - as long as it's not your mums/wife/girlfriend's best silver, heat it up over a gas flame so it's hot, but not red hot. Maybe 300 C? Then cut through the rope. The heat melts and seals it. If it's too hot, there will be clouds of toxic smoke and possibly flames. Too cold and it won't cut, so you may need to experiment to get the temp about right.

Second method is cut through it with a cold (ie room temp) sharp knife, then use a cigarette lighter or candle etc to carefully melt and seal the end, gently rolling it with your fingers (careful so you don't burn your pinkies) to get a nice finish.


Mark - 14 Aug 2009

I have tried that, the inner core will cut but since its has spectra in it, it doesnt seem to 'stick' to the nylon outer.


David Wyndham - 14 Aug 2009

A good way of stopping rope fraying when you cut it is to wrap some tape around it tightly then cut just next to the edge of the tape. I have found this combined with a hot knife gives good results on nylon rope.


ed nepia - 14 Aug 2009

the first way is best for spectra, cut core shorter then sheath , roll sheath over core then melt


Mark - 17 Aug 2009

Thanks, I will give the first method a go.


Mark.K - 15 Sep 2009

Yep, first way does work best.

Pinkies did get a little burnt but thats ok. :-)

Keep climbing with us

Keep climbing with us

Keep climbing with us